Nah that’s just in the pictured configuration. The baskets and all the accessories just hook onto the rack frame so you can move things around to whatever config you want. Do the dish baskets on top of each other and leave the ‘flatter’ bits (like the knife block) for over the actual sink, much better config. Thirty second job even with the dishes on them.

I have one of these, too, and I’ve never been able to use it. Would if I could, it’s brilliant! But in my last flat it was too tall to fit under the cupboards, and in my current one it’s too wide to fir between them.

I have a dishwasher, but I use a dish dryer as a ‘pre-washer rack’ because my ADHD ass can never empty a clean dishwasher quick enough to avoid dirty dishes piling up. So the dryer rack keeps dishes from blocking the sink. Stupid problems sometimes require stupid solutions.

I’ve been thinking about some similar use cases recently and came to the conclusion that it’s ultimately about packaging. All the functionalities that are needed are fairly readily available (other replies here have aome good suggestions in Nextcloud and self-hosted Odoo), but the real challenge is to make it easily deployable into and accessible for the community.

My thinking was specifically for the idea of easily connecting and organising building tenants. I want to get to the point where one (or a few) tenants can get together, set up a single boxin a flat in the building, and distribute QR codes to the other tenants that will allow them to access some kind of virtual building community hub. If you’re reliant on a lot of technical know-how to set up or maintain this, that’s going to severely limit its usefulness.